1-800-355-2335 | Mon-Fri: 9am-5pm EST | Contact Us

Return
 
Loop Goop - One Part Loop Sealant

BD Loop Goop is a tough and durable polyurethane resin sealant designed to encapsulate, protect and insulate inductance loops for door, gate, and parking applications. Effectively seals out moisture and provides exceptional chemical resistance to de-icing salts, antifreeze, gasoline, motor oil, hydraulic brake fluid and other hydrocarbons. BD Loop Goop remains strong, flexible and resilient in cold weather. It provides superior adhesion to wires and saw cuts in concrete and asphalt. Application does not require mixing or heating. Permits vehicular traffic immediately after application with no need for lane closure. DOT APPROVED by most States.

To get the most out of your tube of Loop Goop use with a 3/16" wide saw blade, and 3/16" Preformed Saw-Cut Loops.

There is a minimum order of two cartridges.
 

Q-Seal 290S

BDLG-BlackTube Black Asphalt Sealant - 30 oz. tube - MINIMUM ORDER OF 2 TUBES $/each Add to Cart | View Cart
BDLG-GrayTube Gray Concrete Sealant - 30 oz. tube - MINIMUM ORDER OF 2 TUBES $/each Add to Cart | View Cart
PRICE SHOWN DOES NOT INCLUDE SHIPPING


COVERAGE PER TUBE:

BEST SIZE

3/16" Wide Saw Cut
Depth Length
Per Tube
1-1/4" 20ft
1-1/2" 16ft

25% Larger

1/4" Wide Saw Cut
Depth Length
Per Tube
1-1/4" 15ft
1-1/2" 12ft


SURFACE PREPARATION:

Wash and blow out saw cuts with compressed air (such as the BD Loops Air Wand) to remove dust, debris and standing water. It is recommended that ambient temperatures at the time of sealant application should not exceed 100F (38C) nor fall below 36F (2C). Do not apply to wet or icy surfaces. Curing time will be lengthened below 36F (2C) and shorted above 100F (38C).

APPLICATION:
Cut the tip of the Loop Goop cartridge using a safe tool. Tightly screw the disposable threaded nozzle in place and insert the cartridge into the caulking gun. Apply sealant from the bottom of the saw cut to within 1/8 (3.12 mm) of the roadway surface. Pneumatic and battery powered dispensing guns are available.

CURING:
Will skin over in approximately 3 hours at 77F (25C) and 50% R.H. Hotter, more humid weather speeds up curing; cooler, dryer weather slows it down. Full cure will take several days, however traffic is permitted immediately after application.

CLEANUP:
For product handling and clean-up wear disposable latex gloves, rubbing alcohol helps clean up spills. If you are unsure if rubbing alcohol can be used on a surface/finish, first test clean a small inconspicuous area to see if damage occurs.

STORAGE:
For maximum shelf life, store in a dry, cool place.

NOTES:
Loop Goop Loop Sealant exhibits exceptional chemical resistance to the following chemicals:

SAFETY & HANDLING:
Keep away from heat and open flames. Use only in well ventilated areas. Do not breath vapors. In case of contact, immediately flush eyes or skin with plenty of water for at lest ten minutes. If contact is made with eyes, get immediate medical attention.