1-800-355-2335 | Mon-Fri: 9am-5pm EST | Contact Us

Return

CLICKER - CLT-1 - Determining Brand
Home Page

Clicker Index

Compatiblity Chart

Programming
-Determining Brand

-Section I
  Chamberlain
  Sears
  LiftMaster
  Dolt

-Section II
  Stanley
  Multi-Code
  Linear
  Moore-O-Matic

-Section III
  Genie 9 Code
  Genie 12 Code                      

CLICKER
Universal Garage Door Opener Remote Control

Universal Garage Door Opener Remote Control

The clicker remote can be programmed to operate up to 2 garage door openers or gates, including different brands. All programming is done using the:

  • Brand switch
  • Transmitter DIP switch
  • Transmit push buttons A and B, and LED indicator

Preparation

Determine the BRAND of the existing garage door opener or handheld remote controls. If all remote controls are lost, the BRAND is located on the ceiling mounted motor unit or on the receiver near the flexible wire antenna. Proceed to the SECTION indicated on the BRAND chart below.

Note: If programming to more than one opener, after programming button "A" refer to brand chart, and follow the instructions pertaining to the brand you wish to program into button "B".

When the remotes range is diminished, operation is intermittent, or the LED dims, replace the battery. Memory is not lost when the battery is removed. Note: Dispose of old batteries properly.

clt1-img2.jpg (30638 bytes)

clt1-img3.jpg (23362 bytes)

BRAND CHART: Proceed to appropriate section.

SECTION I    Chamberlain, Sears, LiftMaster, Master Mechanic, Dolt
SECTION II   Stanley, Multi-code, Linear, Moore-O-Matic
SECTION III  Genie