1-800-355-2335 | Mon-Fri: 9am-5pm EST | Contact Us

Return

CLICKER - CLT-1 - Programming
Home Page

Clicker Index

Compatiblity Chart

Programming
-Determining Brand

-Section I
  Chamberlain
  Sears
  LiftMaster
  Dolt

-Section II
  Stanley
  Multi-Code
  Linear
  Moore-O-Matic

-Section III
  Genie 9 Code
  Genie 12 Code                      

SECTION I - Chamberlain, Sears, LiftMaster, Master Mechanic, Dolt
Determine if your motor unit/receiver system has DIP switches or a smart-learn button. (Locate the small gray wire antenna. Some models require removing the light lens.)

Chamberlain, Sears, LiftMaster, Master Mechanic, Dolt Replacement Transmitter CLT-1, Clicker Brand

- If the Receiver has 9 DIP switches proceed to TYPE A
- If the Receiver has a yellow, white, or gray smart-learn button,
  proceed to TYPE B
- If the Receiver has a green, red, or orange smart-learn button,
  proceed to TYPE C

TYPE A: The Receiver DIP switch has three positions labeled "+", "0" and " - ". The "0" setting cannot be used with the clicker remote.

1) Reset switches: 1 to " - " and positions 2 through 9 to a random setting using  "+" and the " - ". DO NOT USE THE " 0" SETTING.

2) Gather any existing remotes and open to expose the DIP switches. Reset the  DIP switch to match the newly coded receiver. Note: some three button remotes do not have a #1 switch. Match the 2 through 9 to the receiver. On three button  remotes the large button is now programmed to activate the door.

3) Test all the newly coded remote controls to be sure that they operate the door before proceeding to the BRAND MODE SETTING.

TYPE B: After determining that the Receiver has a yellow, white or gray learn button:

1) Gather any existing remotes and open to expose the DIP switches labeled "+", "0" and " - ''.

2)
Reset switches: 1 to "-" and positions 2 through 9 to a random setting using "+" and the " - ". DO NOT USE THE " 0" SETTING, SET ALL REMOTES TO THE SAME SETTING. On three button remotes the large button is now programmed to activate the door.

3) The recoded remotes must be programmed to the receiver. Press and release the smart-learn button. Then press and hold the existing remote push button for three seconds.

4) Test all the newly coded remote controls to be sure that they operate the door before proceeding to the BRAND MODE SETTING.




TYPE C: With this type receiver, the existing remotes do not contain DIP switches. Proceed to BRAND MODE SETTINGS.

BRAND MODE SETTINGS - Set switches on clicker remote
FOR TYPE A & B - Step 1



Continue to Step 2

FOR TYPE C - Step 1

Continue to Step 2

Step 2 - Press and hold both buttons for 5 seconds or              until LED begins to flash.
Step 3 - When LED flashes, release both buttons
Step 4 - Press the button you wish to operate the
             opener (your choice).

For type A & B, proceed to step 6.
For type C, continue on to Step 5

Step 5 A. Press and release the Smart-Learn button. B. Press and hold button selected in Step 4 for 3 seconds
 
Step 6 - Programming is complete, to test, press the button selected to
               activate garage door.