The acquisition time from the emitter light source and the discriminate module is approximately .5 seconds.

The Fire Strobe 2000 is widely used for security/electric gate access. It can be used for firehouse garage doors, and other related access needed for emergency vehicles   This emergency vehicle strobe detector provides rapid access to any gated community that has been serviced by fire and emergency equipment on the OPTICOM Strobe System.(™ of 3M).
 

• Fire
• Paramedics
• 911 Response Vehicles

• Frequency Changes
• 2 Delay Outputs
• Relay Timing

• Fire Strobe 2000 can be installed on any existing gate system
• Sensitive photodiode complete with PVC housing and lens assembly can be mounted in a variety of ways
• Fire Strobe 2000 is designed to accommodate AC or DC operation
• Units are provided with 12 VAC plug in transformer

The photoeye is typically mounted 8 to 10 feet above street level and is aimed for optimal strobe signal. [A total of (2) photoeye assemblies may be used]. A 12 VAC power supply is provided with the Fire Strobe 2000 system.

Testing can be accomplished with the optional fire strobe transmitter tester. This Fire Strobe 2000 transmitter will enable a throughput of signals from the photoeye assembly to the relay output. This is a hand-held transmitter which operates via 9-volt battery. The transmitter tester has a limited range of 6" and must be held up to the photoeye assembly during the test phase.
 

• Frequency 14.035 Hz+/- .25 Hz for class II signals. Optional frequencies available.
• The Fire Strobe 2000 is fully compatible with the OPTICOM™ priority control emitter.
• The strobe acquisition time is approximately .5 seconds.
• The PC board construction is mounted in the enclosed 8" x 8" x 4" rain-tight NEMA J-box.
• The weight is approximately 7 pounds.
• The power requirements are 12/24 volts AC/DC non polarity conscious, approximately 1 watt draw.