|
| Model 4200 Manual Index
|
|
Multi-Code Model 4200 Wireless Keypad ACCESS CODE PROGRAMMING To begin programming or change the access code press the "access learn" key twice. (The LED indicator light will turn on, indicating learn mode. During the learn mode, the LED indicator will blink with each keypress). Now enter the old access code (Note: for the first time programming this would be the factory preset code 1,2,3,4) Next enter the new 4 digit access code. Finally press the "access learn: key to end the programming sequence. (See Example 2) If the LED indicator turns off when the "access leran" key is pressed, the new access code has been successfully programmed. If the old access code has been incorrectly or more than 4 keys were entered for the new code during the programming, the LED indicator will blink at a fast rate for 4 seconds when "access learn" key is pressed, then turn off. This indicates an error in the programming procedure and the access code will remain unchanged. (NOTE TO RESET THE RF PROGRAMMABLE KEYLESS ENTRY TO THE FACTORY RADIO CODE AND ACCESS CODE, REMOVE 9 VOLT BATTERY FROM UNIT, DEPRESS ANY KEY ON THE KEYPAD AND WAIT 10 SECONDS BEFORE INSTALLING THE BATTERY.)
|
|||||||||||
|
