1-800-355-2335 | Mon-Fri: 9am-5pm EST | Contact Us

How To Install Manual - Chain Link Cantilever Gate
By Chad Hoover, CFP

[ 1 ] Overview [ 2 ] Plan [ 3 ] Layout [ 4 ] Set Posts [ 5 ] Install Fittings [ 6 ] Hang Gate [ 7 ] Install Latch [ 8 ] Install Operator

Click to Enlarge!
6' High x 20' Wide Opening Single Cantilever Gate - Hoover Fence Co.
6'H x 20'W Single Gate

6' High x 30' Wide Opening Double Cantilever Gate - Hoover Fence Co.
6'H x 30'W Double Gate

Before You Begin:
  1. Obtain necessary zoning and building permits.  There may be local zoning or deed restrictions pertaining to height and type of fence and/ or gate. Check out property line setback requirements. Find surveyors pins if the fence is to be located near property lines or have the lot surveyed.
  2. Measure fence footage and locate gate placement.
  3. Call before you dig. Notify your local or state utilities protection service to locate potential buried utilities. There is usually no charge to locate utilities, however a hefty charge could exisit for repairing buried utility lines, not to mention a potential injury to yourself.
  4. Purchase fence, gates, and hardware direct from HooverFence.Com:

Continue with Installation Manual for Cantilever Slide Gates - Hoover Fence Co.

Click to Enlarge!
6' High x 18'W Sliding Cantilever Gate - Hoover Fence Co.
6'H x 18'W Single Gate

6' High x 20' Wide Sliding Cantilever Gate - Hoover Fence Co.
6'H x 20'W Single Gate