|
C:\fencecom\public_html\hooverfence\server-side\gto-left-menu.htm
|
Sorry,
this operator has been discontinued.
See left menu for available operators.
Product Code: PRO-SW2500
 GTO/PRO Swing Gate Operator |
PRO2500 for Single Gates
PRO2500 and PRO2550 for Double Gates
|
Low Voltage Swing Gate Operator designed for tubular steel,
vinyl, wood, or ornamental gates for residential, farm and light commercial use. The
PRO2500 is for single swing gates. Add the slave unit PRO2550 for a double swing gate
(below). Read our frequently
asked questions page for more information. If you still need help, e-mail sales@hooverfence.com
- 12 volt system, no electrician needed for
installation
- Gate will work during electrical power
outage
- Quick and easy installation, with user
friendly instructions
- Solar Panel Charger available for remote
locations
- Will operate a gate up to 16' long and weighing up to 500
lbs. each leaf.
- Can operate 100 or more gate cycles per day
using transformer charger, depending on gate size and weight (see cycle chart link below)
- Large control box with room for extra
battery and accessories
- Receiver unit with antenna and 10' cable can
be placed in best location for reception of signal
- Can be operated by remote transmitter,
digital keypad, push button or combination
- Full systems capable "add on ready" heavy-duty
control board includes adjustable obstruction sensing, gate sequencing and auto close
settings (0-120 seconds).
- High cycle capability with true soft start and stop
operation.
- Full access ready package includes battery, radio receiver,
entry transmitter, AC transformer, and all necessary mounting hardware for a standard
installation.
- Can operate as 'push to open' or 'pull to
open' (specify when ordering - extra hardware required for push to open)
- UL rated for Class I, II, III & IV. System certified to
be in compliance with UL 325, 5th edition.
- 18 month limited warranty applies to
replacing parts from GTO, Inc.
- 30 day satisfaction guarantee from Hoover
Fence
Technical Specifications:
- Powered by reliable 12 volt DC motor, 64:1 planetary gear
drive system.
- Temperature rating of motor: -5º F (-28º C) to +160ºF
(+71ºC)
- Opening time is 20-24 seconds.
- Range of arm stroke is up to 22" (56 cm), with arm
fully retracted is 40.25" (102 cm), mounting point to mounting point.f
|
- The PRO-SW2500 system is powered by a 12 volt DC/7.0 amp
hour, sealed, rechargeable battery.
- Optional second battery fits in control box, used for solar
applications or high traffic applications, if needed
- Battery charge maintained by a 120V AC/60 Htz input at 40VA
output, transformer rectified to 14 V DC through the GTO Control Board. NOTE:
Transformer should never be connected directly to any battery.
- Optional GTO Solar Panel Charger: float voltage 14.5 V DC
output from a 19-3/8" (49.21 cm) x 15-1/4" (38.74 cm) silicon alloy panel.
Generates minimum of 10 watts at 600 mA. A gated diode on the control board prevents
battery discharge.
|
- The GTO control board can be programmed for pull-to-open or
push-to-open.
- Adjustable auto close, obstruction sensitivity and dual gate
sequencing.
- Slow Start/Stop for added cycles and system life.
- Auto-memorization of digital transmitter code.
- Charging regulated circuit on control board. "Sleep
draw" is 40 mA; "active draw" is 2 to 7 amps.
- GTO remote-mounted RF receiver tuned at 318 MHz.
|
Includes:
- Operator arm
- AC transformer
- 12 volt battery
- Control box/control board
- Receiver with 6 ft. cable
- Entry transmitter
- 6 ft. power cable
- Mounting hardware
- Installation/safety manual
- Caution signs.
- Warning Beeper
- Adjustable obstacle-reversing safety feature
|
GTO/PRO SW2500
|
Product
Code: PRO-SW2550
GTO Slave Operator for PRO2500 only
Add this unit to the PRO2500 above and your system will
operate a double swing gate up to 32' wide (16' each leaf). Burying the power cable
directly across the driveway is fine. It can be snaked through conduit also. Cable is 1/4
inch diameter with a 1 inch plug on one end only.
Includes:
- Operator arm
- 40' power cable - wires into the control box of the PRO2500
- Mounting hardware
- NOTE: This operator will not work as a stand-alone
unit. It is a slave unit without a control box and is meant to hook up to the PRO2500
control box for use with a double gate.
|
GTO/PRO SW2550
|
Included parts
PRO-SW2500/2550
Installation Manual
PRO-SW2550 Swing Gate Operator
$0.00 Add To Cart || View Cart
includes ground shipping to USA. Hawaii
and Alaska extra.
or by phone: 800-355-2335 toll free
|
