1-800-355-2335 | Mon-Fri: 9am-5pm EST | Contact Us

Style UAS-100 Pictures (Ultra Style UAS-100 with Short Spears)

Click to enlarge!
click image to enlarge

Click to enlarge!
click image to enlarge

Shown here is 4 foot high style UAS-100 fence. A drive gate is installed on the left with an arbor attached on the right side. The fence is attached to wood posts on the gate side with an aluminum line post between the fence sections. This customer actually built his own gate using fence sections. Usually gates must be ordered to provide the strength needed to handle the load that is applied to it when opening and closing. Gates are built with extra support to handle the slamming it receives and are highly recommended to prevent the possibility of the gate sagging. Drive gates should be ordered in most cases, especially if a gate operator is going to be used. This picture shows the same style only the customer made a unique transition on the right side with sloping pickets dropping down about six inches. The fence section is attached to the wood posts with rail end brackets. The line posts between the sections are routed to accept the rails of the fence sections. The transition post would have had to be ordered as an end post to accept the 4 foot high section with the customer routing his own holes in the post on the lower section or else the top rail hole would show on that side. Using his imagination, this customer came up with a unique fence to make an attractive entry to his home.
Thanks for the pictures Dennis M., White Plains, NY
Links:
Style UAS-100 Fence
Arbors
Installation Tips