Aluminum Fence Vinyl Fence Wood Fence Chain Link Fence Aluminum Railing Vinyl Railing Gate Operators Access Control Fence Tools Gates/Hardware View Cart Search

Model VS-GSWG Swing Gate Operator
Variable Speed
Industrial

The OSCO Model VS-GSWG is a heavy-duty variable speed swing gate operator designed for smooth, secure and reliable operation of large, heavy swing gates. The positive locking linear drive arm design provides enhanced security, plus increased ability to withstand high wind loads - especially important for large, heavy gates. The VS-GSWG features the same proven and reliable UL325/UL991 compliant solid state control circuitry as the rest of the OSCO family of gate operators and is available in 1/2, 1 or 2 HP, 115V-460V single- or three-phase power. The VS-GSWG utilizes an inherent current sensing system for entrapment protection and is listed for use in UL class I-IV applications. The variable speed operator starts and stops at a slower speed. This is less stressful on the operator and gate and saves wear and tear on the components. It may add a few seconds to the opening speed but is well worth the extra time in avoiding the sudden jerking of the operator at the start and slamming of the gate at the stop.

VS-GSWG Specifications / Features

Cabinet:

• Weather-resistant galannealed steel cabinet with powder coat finish
• Lockable, gasketed and removable front cover for easy access

Mechanical:

• Heavy-duty 60:1 right-angle C-face gear reducer
• Adjustable torque limiter
• Linear drive arm (60" arms standard, specify 75" arms for gates 17' and wider)
• Heavy-duty pillow-block bearings

Mounting:

• 3-1/2" OD post mounting brackets
• Optional pad mounting pedestal available

Anti-Entrapment/Detection Devices:

• Operator is pre-wired to accept contact and non-contact detection devices such as contact edges and/or photo electric eyes

Manual Release:

• Manual release is easily accessible

Control Circuit:

• Solid state ciruit board, 24 VDC
• Inherent current sensing system
• 15 LEDs for easy setup and troubleshooting
• Built in maximum run timer and auto close timer
• Right-hand/left-hand easy conversion
• Master/Slave - simple three-wire connection
• Entrapment Alarm

Warning Signals:

• Warning beeper to sound when gate is moving

Electrical:

• Variable speed - soft start/soft stop programmable through an inverter motor control
• Available from 1/2 to 2 hp industrial continuous-duty, three phase, 56-frame motor
• Available in all standard voltages and phases
• Emergency stop/reset button on front cover
• Run timer for clutch and motor protection
• Delay on reverse
• Master/Slave capability built in
• Easily convertible right hand/left hand
• Solid state control circuit
• Double C-face brake
• Power on/off switch
• Duplex receptacle on 115 VAC units
• Three-button control station included
• Accessory connections are 24 volt AC or DC
• Easily adjustable rotary limit switches
• Fully compatible with our entire line of Gate Operator Accessories including card control, loop detectors, radio controls, and automatic closing devices
• Low voltage surge suppressor included

Manual:

• VS-GSWG Gate Operator Manual (PDF)

Warranty:

• The VS-GSWG is backed by a manufacturer's 5-year warranty.

WARNING: All electric powered gates should have electric       
edge or photo electric control for  safety. Purchased separately

   
Add another operator for double swing applications
Master/Slave capability is built in

OSCO products listed here and other related pages are registered trademarks of OSCO, Inc.