Linear Swing Gate Opener - 12 Volt (500 lbs./16 ft.)

Linear Pro Access PRO-SW2000XLS Swing Gate Opener (Formerly GTO PRO-SW2000XLS)

The Linear PRO-SW2000XLS will go above and beyond your expectations, meeting all of your residential gate opening needs. The 2000XLS Gate Operator is intended for use with vehicular swing gates in single family residential applications. Designed for use with tubular steel, vinyl, wood, or ornamental gates. The PRO-SW2000XLS is for single swing gates, and will operate a gate up to 16 ft. wide and weighing up to 500 lbs. Note: Ball bearing hinges should be used on all gates weighing over 250 lbs (113.4kg).

This 12 Volt Electric Gate Opener does not require an electrician to install, allowing for a quick and easy installation along with user friendly instructions. It is also solar compatible, combine with a Solar Panel for a Solar Powered Gate Opener that is ideal for rural areas or as protection against extended power outages.

Can be operated by remote Transmitter, digital Keypad, Push Button or a combination of accessories. Combine with an Exit Wand to create a fully Automatic Gate Opener on exit.

• Dual Sense Technology
• Cost Efficient - No need for additional entrapment protection devices
• Quick Install - No electrician/welder or photo beams required
• UL325 Compliant - U.L. rated for Class I. System certified to be in compliance with U.L. 325, latest revision.
• Easy transmitter programming with the touch of a button
• Control box has integrated receiver.
• Soft Start / Soft Stop
• Solar Compatible
• Includes battery backup, 318 MHz RF radio receiver, entry transmitter, AC transformer and all necessary mounting hardware
• Full systems capable "add on ready" heavy-duty control board includes adjustable obstruction sensing, gate sequencing and auto close settings (3-120 seconds).
• Works on all types of gates: Chain Link, Tube, Panel, Ornamental, Wood, and Vinyl
• 2-year Warranty (residential applications only)

• 12 Volt DC / 7.0 amp hour, sealed, rechargeable battery (included)
• Battery charge is maintained by a 120V AC/60 Hz input, 18V AC, 40 VA output transformer regulated to 14V DC through control board
• Solar Panel Charger available for remote locations.
• Gate will work during electrical power outage.
• Powered by a reliable 12 Volt (120 Watt) DC motor
• "Sleep draw" is 15 mA; "active draw" is 2 to 5 amps.
• Can operate 60 to 165 gate cycles during peak hours of operation, depending on gate size and weight (Cycle Comparison Chart)

• Larger, higher powered, lower RPM motor
• Reduced gear motor noise
• Increased operating speed by 10%
• Controller with Jog Button technology
• Extended Cycle Life - Enhanced motor design makes this opener ideal for today's single family homes or ranches
• Front mount and scraper seal design
• Rev-counter board with reed switch technology
• Reinstated heavy duty hardware for 500lb-16ft gates
• The control board can be programmed for pull-to-open or push-to-open (extra hardware required for push-to-open)
• Operating temp -5°F (-21°C) to +160°F (71°C)
• Opening time: From 15 to 20 seconds
• Range of arm stroke: is up to 15" (33 cm)
• Operator length with arm fully retracted is 33.75" (85.2 cm)
• Operation, diagnostic and safety alarms
• Inherent obstruction sensing
• Soft start/soft stop — for long mechanical life expectancy
• Auto close adjustable 3–120 seconds delay

• Operator arm.
• AC transformer.
• 12 volt battery.
• Control box/control board.
• Integrated receiver with external antenna.
• Entry transmitter.
• 6 ft. power cable.
• Mounting hardware.
• Installation/safety manual.
• Caution signs.
• Warning Beeper.
• Adjustable obstacle-reversing safety feature.

NOTE: 16 gauge, dual conductor, multi-stranded, direct burial, low voltage PVC sheathed wire required for installation - Not Included.

Linear/Mighty Mule Gate Operator Overview