Wall Mount Butt Hinges
These chain link gate hinges are priced per hinge, not by
the pair. Two are required for most single gates, four are required for most double gates.
Gates taller than 8' should have three hinges per leaf. These hinges will fit
1-5/8" O.D. and 2" O.D. gate uprights simply by moving the collar on hinge.
Hinges are very easy to install and are recommended if gates are to be automated. The
curved portion of the hinge simply bolts around the gate post. The flat plate
portion is mounted to a wall or flat surface. The hinge must be positioned so that one of
the horizontal rails rests on the collar. You may bolt hinges just below the top
horizontal rail, or build your gates so that they have a longer leg on one side to slide
into the butt hinge.
These hinges allow for a 90 degree swivel in either
direction. To allow hinges to swing a full 180°, you will need one 180° adapter per
hinge found here: Page 27a 180° adapters are easy
to install. The U-bolts bolt around gate frame, 1-5/8" or 2", and the 'leg'
portion simply slides into butt hinge. Pictured at right is a standard industrial pressed
steel butt hinge with a 180º adapter installed.
|Sold individually, pricing displayed
is per piece. Buy in Bulk and Save! Discounts will automatically apply when carting
Case Quantities or more.
|Wall Mount Butt Hinges|
|CL-BH-WM||Adjustable to fit
1-5/8" or 2"
|4.0 lbs||5||$||Add to Cart|
*Buy in Bulk and Save! Discounts automatically applied on Case Quantities or more!
Note: These photos are for demonstration purpose only, actual size and design may vary slightly. Weights shown are approximate.
Order Online Using Our Secure Shopping Cart or Call Hoover Fence Co. 1-800-355-2335