The PRO-SW1500/2000/2500/3000/4000* swing gate operator arms secure with a clevis pin at each end of the
operator arm; one on the gate, the other on the post. Anyone can remove those pins and
walk off with the operator arm. To avoid such a nasty loss, purchase one RB345 lock for
each operator arm. That way they can not steal the arm and yet you can unlock and remove
the lock to get the gate open in case of failure of the operator. Pin Locks are
recommended on front mount only. The same lock can also be used with all Mighty
Mule gate operators. The RB345 master pin lock may also be used with the SL1000B and
SL2000B slide gate operators. This would fit above in the bracket that attaches the chain
to the gate to lock the chain on. The 'quick release' would no longer be 'quick release'.
The master pin locks would lock the chain on so that anyone without a key could not get
in. Typically two per operator would be needed. The FM345 can also be ordered
"keyed-alike" for convenience, available in lot of 10 only.
* Master Pin Lock shown can only be used
on the front mount with the PRO-SW3000XL(S) and PRO-SW4000XL(S) series operators with the large
square post pivot brackets.
FM345 - Master Pin Lock for
and SL1000B/SL2000B, as well as all Mighty Mule Models
$ eachAdd To Cart
| View Cart