BD Loops 2-Part Loop Goop Sealant with Static Mixing Tip - MINIMUM ORDER OF 2 TUBES

Item # BD-LG2-SINGLE

Actual product(s) may vary from pictures shown

Details

BD-LG2 is a two component polyurethane, detector loop sealant. It is designed for use in both asphalt and concrete pavement to provide a weather and chemical resistant waterproof seal. BD-LG2 effectively seals out moisture and provides a tough and durable seal. Permits vehicular traffic immediately after application (see BDLoops.com for installation tips) with no need for lane closure.

BD-LG2 is designed for sealing loops in cold or freezing temperatures. BD-LG2 Detector Loop Sealant exhibits Exceptional chemical resistance to de-icing salts (including 50% by weight potassium acetate), gasoline, hydraulic brake fluid and motor oil. BD-LG2 requires no clean up since the mixing tips are disposable.

Uses:

BD-LG2 is primarily used as a fast cure, protective seal for inductance loops. It may be used as a sealant for saw cuts in concrete and asphalt surfaces.

BD-LG2 cures in cold and freezing applications. Finally a solution for sealing loops in cold weather!

Curing:

BD-LG2 will gel in only 8 - 15 minutes at 77°F (25°C). This product will take longer to gel at temperatures below 77°F (25°C). See the "Gel Time in Saw Cut" chart below. The cure will also depend on the vol-ume of material applied. Contact your BD Loops Distributor for more information.

Temperature	Gel Time
23°F (-5°C)	120 Min.
41°F (5°C)	45 Min.
59°F (15°C)	15 Min.
Greater than 59°F (15°C)	Less than 15 Min.

Specifications

BD-LG2 has no reaction with the asphalt and concrete and therefore will not deteriorate them. It exhibits no "bubbling" or "mushrooming". BD-LG2 will not expand or flow above the joint.

Handling Instructions:

BD-LG2 is a 100% solids system that contains no solvents and is zero V.O.C.

Technical Data Sheet (PDF)

Instructions

Surface preparation: Wash and blow out saw cuts with compressed air (such as the BD Loops Air Wand) to remove dust, debris and standing water. It is the responsibility of the installer to ensure that the substrate are clean and dry (free of dust, water and ice) before installation of BD-LG2. If the substrate is not dry or if it is coated with a thin layer of ice, the surface may be heated with a torch or hot air gun to dry.

Application: Remove D-shape plugs prior to use. Attach static mixer to the end of the cartridges, insert cartridges into gun. Holding the gun vertically with static mixer pointing up gun the material a few times to release the air. Apply sealant to saw-cut groove.

Storage: For maximum shelf life, store in a dry, cool place.

Reviews

There are no reviews yet. Be the first to Write a Review (requires login).

Shipping

Country

State

Zip/Postal

Shipping Expense Disclaimer: All orders are subject to confirmation. Additional shipping expenses, although rare, may apply due to weight, size, location, and/or other variables. Should your order require additional funds to cover the transportation of goods, you will be contacted prior to order processing for approval.