Kee Lite Type L160 Aluminum Pipe Fittings - Smooth Handrail Fittings

Kee Lite Technical Specifications

Kee Lite Size Chart

1. Drill size Z (.413 - .423) hole into post
2. Close handles of L325-RN
3. Use service wrench to loosen nosepiece locknut
4. Screw nosepiece down to meet nosepiece locknut
5. Turn stroke adjuster to 1/16" (0.062) greater than the work thickness of the application lining up bottom of stroke adjuster with required measurement on the stroke rule sticker
6. Open handles as much as possible until restricted by the stroke adjuster seating on the rear body
7. Screw fastener on by hand until tip of mandrel is flush with top of threads
8. Screw nosepiece up to meet bottom of the fastener
9. Use service wrench to tighten nosepiece locknut
10. Place rivet nut into hole
11. Squeeze handles (If fastener did not pull securely, slightly open handles and turn stroke adjuster one-half turn. Loosen locknut, turn nosepiece one-quarter turn counterclockwise, tighten locknut and squeeze handles again.)
12. *You may have to repeat step #11 until the fastener is firm and secured on the application
13. Place collar over hole with rivet
14. Place arm over collar
15. Fasten provided machine bolt to post (hand tightened)
16. Adjust fixture to the desired angle and tighten with screwdriver
17. Drill two (2) size 7 holes into the rail
18. Place rail on fixture and fasten screws securely