1-800-355-2335 | Mon-Fri: 9am-5pm EST | Contact Us

Index to Entry Control
Linear EXA-1000 Omni Directional Remote Antenna

Linear EXA-1000 Omni Directional Remote AntennaThe Model EXA-1000 Omni-directional Remote Antenna is designed to enhance the radio range of Linear's receivers. This antenna can be connected to the F connector on many Linear receivers to improve their range when they must be located in poor signal reception locations. Usually an increase of 20-30% range can be expected. The versatile EXA-1000 can be mounted in a variety of ways. A 2-inch U-bolt is supplied for post or pipe mounting, or the U-bolt holes in the Base Plate can be used to screw the antenna to a wall or vertical wood brace or beam. NOTE: Generally, the higher the antenna is mounted above ground level, the better the radio range will be. The EXA-1000 is a 1/2 wave, center fed, vertical antenna composed of three parts: an Antenna assembly with an F connector attachment; a Base Plate assembly with radial mounting provisions; and a five-foot, 75-ohm coaxial cable. The cable connects to the antenna base on one end and the receivers F connector on the other. If the antenna must be mounted further than five feet from the receiver, an extension cable of up to a maximum of 25 feet may be used instead of the five foot cable supplied. Because of the cable resistance, the performance of the EXA-1000 may be degraded by using longer than a 25 foot cable.


  • Omni-directional remote antenna
  • Includes 5 feet of coax
  • U-bolt for post mounting
  • 3" W x 19.5" H x 6" D
  • EXA-1000 Manual