Hoover Fence Commercial Chain Link Fence Rolling Gates, All 1-5/8" Galvanized HF20 Frame

Our Commercial Chain Link Rolling Gates are a great solution for securing openings while minimizing the footprint of the gate. This style of gate slides parallel with the fence line using a track and wheel system.

Residential rolling gates are suitable for Residential, Commercial, and Light Industrial use. We fabricate these gates from all 1-5/8" O.D. HF20 pipe and tube. Chain Link fence fabric is 9 gauge galvanized with a 2" mesh. Tension bands and bolts secure stretch of wire to frame. 9 gauge aluminum tie wires are used at the top and bottom.

This style of gate does not require a large counterbalance like it's Cantilever Slide Gate counterpart, which would be recommended if a larger opening is required, or if the gate is to be automated.

9 ga. extruded black, brown, or green fabric can be substituted at no charge. Make sure to note in special instructions when placing your order.

Note on Sizing/Design:

Gates are 6" shorter than the height shown in order to make room for the bottom wheel, while matching up with the fence height. Gates are also built 12" longer than the width shown to allow the whole opening to be closed off. This extra length pushes the back edge of the gate past the terminal post and allows the necessary room for the rear wheels.

Gates 5' high and higher have a horizontal brace. Gates over 7' wide have a vertical brace. If both dimensions are exceeded, gates will have both vertical and horizontal bracing.

Rolling Gate - System Overview

Ordering Notes:

Prices do not include the rolling gate hardware. We offer pre-packaged Rolling Gate Hardware Kits, along with all of the separate components to create your gate system. If you are purchasing a complete Residential Chain Link Rolling Gate System then you will need to order the following components in addition to the gate itself:

• Double Wheel Carrier - Typically (1) Per Gate
• Rear Wheels with 1-5/8" Brackets - Typically (2) Per Gate
• Pipe Track Brackets - Typically (2) Per Post That You are Mounting 1-5/8" Pipe Track To
• Rolling Gate Latch - Typically (1) Per Gate
• Chain Link Fence Posts - Varies Depending on Size of Gate
• 1-5/8" HF40 Tubing for Track - Varies Depending on Size of Gate