1-800-355-2335 |
Mon-Fri: 9am - 5pm EST |
Contact Us
Twist Tight Ties™ draw in a complete diamond for tighter fabric tension. That means less fabric vibration to prevent false security alarms. They are pre-shaped for a variety of fencing situations. Ideal for security applications. Ends are twisted opposite the fabric making it difficult to take off. Yet, they are easy to install with our custom drill bit tool. Designed for correctional installations with 2-inch mesh. For high traffic, high security areas use the ties that twist on the side.
Contractors report a 3 to 1 installation advantage over hand tying nine gage steel hook ties. The secret is in the wire. Easy Twist and Twist Tight Ties are constructed with a maximum low tensile strength of 75,000 psi compared to a minimum of 110,000 psi from other companies.
Meets ASTM F 626-6.1.2 specifications as well as Federal Bureau of Prisons, Army Corps of Engineers, Federal Aviation Administration and state and local correctional facility specifications.
Also Available by Special Order - Please Call for Quote
Sizes: 3-12"
Shapes: Side Twist, Mini Mesh, Welded Wire
Color: Woodland Green
Twist Tight™ Ties
The ties will be preformed steel wire ties. It shall be preformed in the shape designed to fit around the post or rail, and over at least two sides of a diamond of the chain link fabric. The two ends shall come together and are long enough to be power twisted with a tool. The twist shall be at least three full twists equivalent to one and one half machine turns, drawing the chain link fabric tightly to the post or rail thereby increasing the effectiveness of perimeter security detection devices through reduction of false alarms due to environmental causes.
The twisted ends shall lay opposite of the fabric side away from human contact to reduce the possibility of untwisting the tie.
If contact is unavoidable on the twisted side, the protruding "tail" shall be bent down to the pipe to prevent injury. Or the tie design for side application may be used as an alternative in lower security applications that allow contact with the "tail" (or termination point of the tie).
No less than a nine gauge wire should be used with a 1.8 ounce galvanized coating or 1.2 ounce if the chain link mesh is 1.2 ounce, or .04 ounce aluminized.
Tie should meet ASTM F 626-96a (2003) 6.1.2.1 Power Fastened Round Wire Ties.
There are no reviews yet. Be first to Write a Review (requires login).
